Yes, You Do Need to Clean Out Your Keurig — Here’s How

This story is part of Home Tips, CNET’s collection of practical advice for getting the most out of your home, inside and out.

When you are utilizing your Keurig to brew espresso morning after morning, it is inevitable that gunk will accumulate over time. Mineral buildup can have an effect on how the espresso maker performs — and if sufficient of that grime reaches the interior workings, the Keurig would possibly cease working altogether. You can stop this by giving your favourite caffeine machine a correct wipe-down once in a while. 

The brewing system, drip trays and water tanks all require frequent love and a focus. Even the outside of your machine will collect unsavory stains, fingerprints and different marks of grime. Here’s how to sort out these points earlier than issues get too far out of hand. (You may also study how to organize your fridge, and take a look at our picks for the best cold-brew coffee makers.)

Read extra: Best Coffee Makers for 2022

Wipe the skin of your Keurig brewer with a humid fabric.


Brian Bennett/CNET

1. Clean the skin of the Keurig

Start by wiping down the brewer’s exterior. Keurig actually recommends you do that every day. First, ensure that the espresso maker is powered off and unplugged. Next use a humid fabric to wipe away mud and different particles from the skin of the machine. 

Pay shut consideration to the world on the entrance, proper beneath the espresso dispenser. This part sometimes attracts loads of splashes and drips.

If your Keurig brewer’s drip tray seems to be like this then it is time you clear it.


Brian Bennett/CNET

2. Wash the drip tray

Another espresso machine half that is inclined to grime is the drip tray. Liquid from spills typically sits inside it unnoticed. Coffee drips can evaporate right here too, leaving stains behind. A fast hand wash within the kitchen sink will clear up this mess in a jiffy. Warm water and dish cleaning soap does the trick properly. Perform this cleansing process every day.

Clear water in a clean tray

After a fast hand wash within the sink the drip tray seems to be nice.


Brian Bennett/CNET

3. Clean out the water tank

Here’s one other every day cleansing process. That’s to give the identical hand wash therapy to the water tank. Be certain to take away the water filter first in case your machine has one. Depending in your brewer, your tank could also be secure to throw within the dishwasher.

The pod holder was the dirtiest space on my take a look at Okay-cup brewer.


Brian Bennett/CNET

4. Check the pod holder

The dirtiest part of my take a look at Keurig K-Classic brewer was its pod holder. Grounds, dust and dried espresso had shaped a noticeable quantity of crud right here. To repair this, I eliminated the pod holder, and separated it into its two principal components. Then I gave them a water rinse and an excellent scrub with a humid fabric.

You can also need to use a paper clip to clear any particles from contained in the brewer exit needle. The exit needle sits contained in the pod holder. Take care although since that needle is sharp. Be suggested that Keurig recommends you clear the pod holder each week.

A Keurig filling a mug with brownish water

Run a water-only brew cycle to flush out your Keurig espresso machine’s brewing system.


Brian Bennett/CNET

5. Flush out the entire system

Keeping your Keurig machine’s brewing system clear is vital. Dirty {hardware} can lead to undesirable flavors carrying over from the final brew. Tasting pumpkin spice latte in your Sumatra single origin isn’t very best. Bits of grounds or different particles might trigger clogs too, even a malfunction.

To clear the whole lot out, run a every day water solely brew cycle by means of the machine. Make certain there’s sufficient water within the reservoir and that the pod chamber is empty. You can run any cup measurement cycle you want, so long as the mug you are brewing into is giant sufficient to settle for the liquid. 

And when you’ve by no means descaled your brewer, or it has been three months since you’ve gotten, take into account doing so. According to Keurig, you must carry out the process quarterly. You can use both vinegar or the corporate’s special descaling product. Keep in thoughts that it’s a lengthy process requiring no less than 45 minutes (4 hours with vinegar).

Still, descaling will take away any mineral deposits (typically present in faucet water) which may be clinging to your brewer’s inside parts. This in flip ensures your espresso maker brews its optimally designed temperature. 

Once you’ve got accomplished all these steps, wipe down the brewer once more to take away any extra moisture. It ought to now be prepared to brew in tip prime form.

For extra, try how to clean a cast-iron skillet, and how to clean your grill


Now enjoying:
Watch this:

How to clear your Keurig with distilled vinegar



1:32

Image Credit

Leave a Comment